Our Services

CCTV Installation

1. Get the right cables. RG59 Siamese Cable and One Power Cable.
2. Find the right location for your cameras.
3. Find a point of entrance from the outside of the house to the inside.
4. Designate one location for your DVR and Monitor to be stationed.
5. If you purchased a bulk roll of RG59 cable without connections you would need to purchase the BNC connections and crimp each end on, then connect to the DVR.
6. It is recommended that the DVR be connected to your Monitor before turning on their power supply.
7. This can be an easy and entertaining project once you have the appropriate tools and information.

IP Cameras / NVR

An Internet protocol camera (IP Camera) is a type of digital video camera commonly employed for surveillance, and which unlike analog CCTV cameras can send and receive data via a computer network and the Internet.
A network video recorder (NVR) is a software program that records video in a digital format to a disk drive, USB flash drive, SD memory card or other mass storage device.

IP Cameras Types

Analog Solutions

Analog can record straight to a video tape recorder which are able to record analogue signals as pictures. If the analogue signals are recorded to tape, then the tape must run at a very slow speed in order to operate continuously. This is because in order to allow a three hour tape to run for 24 hours, it must be set to run on a time lapse basis which is usually about four frames a second. In one second, the camera scene can change dramatically.

Analogue signals can also be converted into a digital signal to enable the recordings to be stored on a PC as digital recordings.

Another way to store recordings on a non-analogue media is through the use of a digital video recorder (DVR). Such a device is similar in functionality to a PC with a capture card and appropriate video recording software.